Used where foaming is likely to occur and be drawn into the condenser
The inner vapor tube features two, 4 mm drain holes at its base placed 180 to each other and 90 to the upper holes, allowing faster drainage of trap contents back into the evaporation flask
The modified joint on the 570265 series features a square bead for better sealing to rotary evaporator equipment
Manufactured from 33 expansion, low extractable borosilicate glass conforming to USP Type I and ASTM E438, Type I, Class A requirements
Product must be used in compliance with the intended use statement listed on the product or its accompanying product information.
Disclaimer : No part of this site constitute medical advice or nor it replaces any advice provided by healthcare adviser. We urge buyer to take advice from the designated healthcare adviser about usage of any product here or if it is suitable for the buyer. This site takes no responsibility of the consequences arising out of the usage of any product from this site. By buying products from this site, buyer agree that buyer has the knowledge of the usage of the product. All warranties implied or explicitly mentioned here are responsibility of the manufacturer of the product. We are not able to accept any insurance or Medicaid or Medical for any purchase. Our apologies for that inconvenience.
WARNING: There are products on this website which can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov.